Tube Tech MP2A

The TUBE-TECH MP2A Microphone preamplifier/DI is based on our classic MP1A but features improved fidelity and new features.

MP2A is the second in the new range of upgraded microphone preamplifier/DI’s.( The modular PM1A was the first.)

These new preamps features even higher headroom and fidelity than the earlier TUBE-TECH micpre”s. 

Serious listening tests of the MP2A immediately shows a sound quality second to none and places the preamp amongst

a handful of the worlds very best designs.

MP2A features an impedance switch to perfectly match the input to all different types of microphones, including the increasing amount of popular ribbon mic’s. The impedance switch furthermore opens up several creative possibilities in changing the character of the MP2A input.

Gain is adjustable in 2 dB steps. Overload is now indicated with a red LED.

The MP2A DI carries on the tradition of the very good sounding TUBE-TECH DI’s and delivers even better quality

for Bass and Guitar DI recording. A DI input simply doesn’t get any better than this!

 

 

MP2A Technical Description

 

The TUBE-TECH MP2A is a combined Microphone Preamplifier and Direct Instrument amplifier.
The input provides switchable +48 V phantom power, selectable mic. impedance of 600/1200/2400 Ohm,

phase reverse switch, low-cut filter (20 Hz/40 Hz/off), as well as a switchable -20 dB pad.

Gain is adjustable from +10 dB to +70 dB.( 10db steps, coarse +2 dB steps, fine.)

The Direct Instrument Input are unbalanced with a gain ranging from + 10 dB to + 60 dB.

The amplifier is all tube. Input transformer is enclosed in a MU-metal can. Input and output transformers come with a static screen between the primary and secondary wirings. The input and output are balanced as well as fully floating.

 

 

MP2A Technical Features

Tube based push-pull output amplifier

Gain from +10 dB to +70 dB in 2 dB increments

Pad in front of input transformer (-20 dB)

Built-in +48 V phantom power

Overload indicator

Microphone input impedance = 600 Ohm/ 1,2 kOhm/2,4 kOhm

CMRR >60 dB @ 10kHz

Direct Instrument Jack-socket input for various instruments

DI input impedance > 1 Mohm

Frequency Response @ -3 dB: 5 Hz to 60 kHz

Typical noise figure: 5 dB @ 200 ohm